Audio Technica Pro 42

£99.00 Inc VAT

Miniature boundary microphone

  • Very discreet, low profit housing
  • Ideal for use on the alter or installed on a wall for ambient recording
  • Long hard-wired cable with XLRm connector
Audio Technica
Categories: , SKU: MI/CON/ATEC21

The PRO42’s low-profile design assures inconspicuous appearance for surface-mount use in boardroom, school, government, house of worship and other installed applications. Designed for sound reinforcement, broadcasting and recording applications, the PRO42 brings crisp, intelligible audio reproduction to the podium, stage, conference table and beyond.

With a wide-range condenser element and low-mass diaphragm for superior performance, the microphone is equipped with self-contained electronics, eliminating the need for external power modules (requires phantom power from mixer).

DM Music says
“This is a great little mic for use as ambient pickup for recording and conenction to induction loops. Our installation tip is to use sticky back velcro to mount this mic on walls etc – and experiment with location and position until you get the best sound for your needs.”


  • Very low-profile design for minimum visibility
  • Wide-range condenser element with low-mass diaphragm for superior performance
  • Uniform polar pattern for maximum rejection of unwanted sounds
  • Rugged design and construction
  • 25′ (7.6 m) cable permanently attached between microphone and XLRM-type connector

Element: Fixed-charge back plate, permanently polarized condenser
Polar Pattern: Half-cardioid (cardioid in hemisphere above mounting surface)
Frequency Response: 70-14,000 Hz
Open Circuit Sensitivity: -38 dB (12.5 mV) re 1V at 1 Pa
Impedance: 100 ohms
Maximum Input Sound Level: 134 dB SPL, 1 kHz at 1% T.H.D.
Dynamic Range: 105 dB, 1 kHz at Max SPL
Signal to Noise Ratio: 65 dB, 1 kHz at 1 Pa
Phantom Power Requiremens: 9-52V DC, 2 mA typical
Weight: 1.2 oz (35 g)
Dimensions: 1.44″ (36.6 mm) maximum width, 2.14″ (54.3 mm) maximum length, 0.61″ (15.5 mm) height
Output Connector: 3-pin XLRM-type on cable
Cable: 25′ (7.6 m) long, permanently attached


Audio Technica

Audio Technica


There are no reviews yet.

Be the first to review “Audio Technica Pro 42”

You may also like…