Generic filters
Search in excerpt
£80.00 Inc VAT

Passive Headphone Monitor Amp

  • Stereo / Mono Imput Selector Button
  • Dual 1/4 in stereo/mono headphone jacks
  • Dual parallel 1/4″ stereo/mono input jacks
  • Passive
ART
Categories: , SKU: HP/ACC/ART01

Sometimes floor monitors are a problem. There isn’t enough room for them onstage or someone sits in and can’t hear the monitors or the drummer can’t hear them well enough. Or perhaps it’s a pick-up gig or a rehearsal and you didn’t have enough time to set them up. In any case, sometimes it would be preferable just to put on headphones and somehow connect them to the PA. That’s where a headphone tap comes in.
This is a passive device with an input to connect the PA or monitor amplifier and an output to connect the headphones. A volume control regulates the headphone level and internal resistors keep the unit’s impedance high enough to protect the headphones. It also protects the amplifier from encountering too low a load impedance while powering tap units, the speaker system or several tap units by themselves.
The HeadTAP will also work with a stereo headphone amplifier for use in recording situations when you want to add headphones for additional performers.

Input Level Stereo/mono input selector button
Output Jack Dual 1/4 in stereo/mono headphone jacks
Instrument Input Dual parallel 1/4″ stereo/mono input jacks
Dimensions 3.75×2.875×1.5 inches (95mm x 74mm x 40mm)
Weight 0.7lb (317g)
Power Requirements Passive

The HeadTAP provides quick and convenient tapping facilities to permit powering headphones directly from an amplifier.

  •  Dual parallel 1/4” stereo/mono input jacks permit daisy-chaining taps and/or speakers.
  •  Stereo/mono input selector button
  •  Dual 1/4” stereo/mono headphone jacks
  •  Level control
  •  Input impedance: 150 ohms
  •  Dimensions: 3.75 x 2.875 x 1.5 inches (95mm x 74mm x 40mm)
  •  Weight : 1lb (454g)

Brand

ART

ART

Reviews

There are no reviews yet.

Be the first to review “ART HeadTAP”

You may also like…