2 x 250W powered mixer
12 input (8 mic inputs)
4 aux sends
Swept mid EQ 12 channel powered mixer providing 1kW ie. 2 x 500 Watts into 4 or 8 Ohms. 8 mono inputs with 2 stereo channels, 4 aux sends, 4 band EQ on each channel, 4 band semi-parametric EQ is provided in the output section.

The PA12-CP are sturdy, "walk up and go" powered mixers, guaranteed to deliver loads of weighty power from their 'Constant Power' amplifiers. These well thought-out mixers offer operational flexibility for any live sound situation and engineers of any experience.

Features
2 x 500W RMS peak power professional class AB power amplifiers
8 mono channels with Mic [XLR] & Line [TRS] inputs
Two stereo channels with two unbalanced stereo inputs on each
4 Auxiliary Sends from all channels
EQ: Shelving LF [60Hz], and HF [12kHz]. Fixed LM [250Hz], and swept HM [300Hz - 6kHz].

Main stereo mix output has 100mm fader control & mute with LED. TRS jack outputs. Mono sum output with level control with switch for subwoofer mode to TRS jack. Record output [RCA] analogue + SPDIF switchable pre/post fader. Twin 12 segment LED bar meter shows program [or PFL /AFL]. Insert points on TRS jack for external processing. Output EQ and routing to internal amplifiers / external systems is provided.

4 band semi-parametric EQ is provided in the output section, this affects the TRS slave outputs, and the internal constant power amplifiers. This offers more control than graphic equalisers for precise management of speakers, especially foldback / monitors. Source selector allows output EQ section to be used on Left / right, L&R sum / foldback1, or foldback1 / foldback2.

1kW i.e. 2 x 500W RMS peak power professional class AB power amplifiers built in. Unique ALLEN&HEATH design gives full output into 4 OR 8 ohms [rear switch selector]. Output is to locking Speakon™ connectors. Thermal management twin fan system. Full protection - input limiter to prevent clipping, short circuit protection, current limit and DC fault sensing. LED indication of: signal presence, peak warning, speaker protect and temperature. AB amp input TRS break-jacks [normalised to output section / slave out jacks] allow independent use of the power amplifiers if desired. Standby mode switch puts amplifier into protect with speakers isolated.

16 program digital FX processor provides reverbs, delays, chorus and others, inc combined. This FX module takes its feed from the post-fade FX aux on the mono & stereo channels. The output of the FX module is controlled by a 100mm fader with mute & PFL and is routed to the stereo mix and FB1&2 with post fade level controls. At this point, 2 TRS inputs with level control provide a way of combining external FX with the internal unit. Internal FX unit can be switched off to use external only if preferred. A footswitch TRS jack is provided to mute the FX channel.

Background music BGM mode - plays 2 track input into the main mix post fader, allows user to pull down fader (whilst patching, taking a break, or during walk-in) and leave music playing through the amplifiers / speakers. 2 track input [RCA] with level control to L&R - feeds headphone monitor selector [checking recording]. Twin, 3 colour 12 segment LED meter displays active monitor source. Large LED indicates PFL / AFL active - signal overrides L&R / 2TRK monitor source selection. Standby switch uses relays to disconnect the speakers. 2 track output [RCA] analogue + SPDIF allows direct to digital recording. Switchable pre / post master L&R fader. Mono sum out with level [TRS] - mode switch to provide sub feed with 100Hz low pass filter. Phones out [TRS] with level.